#Compressor 4.2.2 timecode repeat series

The following exemptions to the provisions of Global technical regulation No.8 apply Д¦.2.1.1. The technical requirements adopted by the United Nations - Economic Commission for Europe Global technical regulation No.8 вЂ“ ELECTRONIC STABILITY CONTROL SYSTEMS, incorporating corrigenda 1 and 2, shall be deemed to be equivalent to the technical requirements of Appendix A, Annex 9, Part A of this standard.Д¦.2.1. 13-H 00, vehicles will be deemed to meet the requirements of these annexes if compliance can be demonstrated during a Conformity of Production assessment.Д¦.2. In respect of Annex 8, paragraph 3.7 of Annex 9, and Appendices 1 to 3 of Annex 9 of UNECE Regulation No.

#Compressor 4.2.2 timecode repeat series

13-H вЂ“ UNIFORM PROVISIONS CONCERNING THE APPROVAL OF PASSENGER CARS WITH REGARD TO BRAKING, incorporating the 00 series of amendments from supplement 9 and corrigendum to supplement 9 onwards, shall be deemed to be equivalent to the technical requirements of this standard, provided vehicles of categories MA, MB, MC or NA are fitted with an Electronic Stability Control System and a Brake Assist System, both meeting the requirements of Appendix A, AnnexВ 9. The technical requirements adopted by the United Nations вЂ“ Economic Commission for Europe (UNECE) Regulation No. In respect of Annex 8, paragraph 3.7 of Annex 9, and Appendices 1 to 3 of Annex 9 of Appendix A of this standard, vehicles will be deemed to meet the requirements of these annexes if compliance can be demonstrated during a Conformity of Production assessment.Д¦.1. Section 11 Names and addresses of technical services responsible for conducting approval tests and of administrative departmentsДЄnnex 1 communication concerning the approval or extension or refusal or withdrawal of approval or production definitely discontinued of a vehicle type with regard to braking pursuant to Regulation No. Section 10 Production definitely discontinued Section 9 Penalties for non-conformity of production Section 7 Modification of vehicle type or braking system and extension of approval Section 5 Paragraph 5.2.25 - temporary-use spare wheels/tyres (Supplement 8 to Regulation No. The following provisions of Appendix A are not applicable. Vehicles of categories MA, MB, MC or NA must be fitted with an Electronic Stability Control System and a Brake Assist System, both meeting the requirements of Appendix A, AnnexВ 9. Vehicles must comply with the requirements of Appendix A, as varied by part 5 Exemptions and Alternative Procedures.Д¤.2. Refer to paragraph 2 of Appendix A for certain definitions.Д¤.1. Refer to Vehicle Standard (Australian Design Rule Definitions and Vehicle Categories) 2005.ДЈ.2.

Vehicles certified to ADR 31/04 or a later version need not comply with this rule.ДЈ.1.

Other LEP vehicles must comply with ADR 33/вЂ¦Дў.7. Vehicles of category LEP that are fitted with a single foot pedal controlling both front and rear service brakes must comply with this standard. Vehicles of category MB, MC or NA complying with the requirements of ADR 35/вЂ¦ will be accepted as complying with this standard.Дў.6. For the purposes of clause 2.1 a 'new model' is a vehicle model first produced with a 'Date of manufacture' on or after the agreed date in clause 2.1.Дў.5. 1В NovemberВ 2017 on all vehicles of category LEP or NA.Дў.4. 1В NovemberВ 2016 on all vehicles of category MA, MB or MC.Дў.3. 1В NovemberВ 2015 on all new model vehicles.Дў.2. This standard applies to the design and construction of vehicles as set out in 2.1, 2.2, 2.3 and the table below.Дў.1. This standard prescribes braking system requirements for passenger cars. This standard commences on the day after it is registered. This standard may also be cited as Australian Design Rule 31/03В -В Brake Systems for Passenger Cars.Д .2.1. This standard is the Vehicle Standard (Australian Design Rule 31/03В вЂ“В Brake Systems for Passenger Cars) 2013.Д .1.2.